Isuzu Crosswind Owners Thread [continued]

[sgotogs]

not sure kung may nag-post na ng ganitong problem...

last sunday sa mall parking nung pauwi na kami, ayaw gumana ng alarm remote ng '05 sportivo. ang ginawa ko ay yung nakasulat sa manual na reset button sa left side ng dashboard kaya nakauwi naman kami.

pero hanggang pag-uwi namin ay ayaw na gumana. kaya bumili ako ng bagong battery kanina (A27 12v), energizer @ 77 pesos sa handyman. gumana naman ng mapalitan ng battery kaya lang ay parang keyless entry na lang. nawala yung chirp sound pag lock/unlock ng door.

help naman po pano maibalik sa factory setup...

tia

[Sleepcare]

@Sir Benz
Ano ulit yung color ng units mo before na crosswind? I saw one kasi with rota journey's. Kaya iniisip ko kung sayo ba yun.

@sgotogs
1) Enter your vehicle and close all doors
2) Switch your ignition to "ON" position (all gauge lights should light up)
3) Continuously press (HOLD) the "lock" button of your transmitter until you hear 2 chirps. Release hold on "LOCK" button.
Reference from Sir Benzmizer.

[xti]

@sleepcare, really appreciate you replies. im glad my crosswind has a buddy here (same color pa). xti rin ba syo? when did you acquired? again, thanks for your informative post. until my next post if i have other concerns in the future. God bless

[sgotogs]

@Sir Benz
Ano ulit yung color ng units mo before na crosswind? I saw one kasi with rota journey's. Kaya iniisip ko kung sayo ba yun.

@sgotogs
1) Enter your vehicle and close all doors
2) Switch your ignition to "ON" position (all gauge lights should light up)
3) Continuously press (HOLD) the "lock" button of your transmitter until you hear 2 chirps. Release hold on "LOCK" button.
Reference from Sir Benzmizer.

Thanks po, sinunod ko naman steps 1 - 3 pero ayaw pa rin tumunog yung alarm, nagbi-blink lang lights. Parang ayaw pa rin mag-exit sa 'keyless mode'. Eto pa po,, yung silent lock at panic button ayaw gumana. Kailangan na kaya ng re-programming ito?

[Sleepcare]

@xti-No prob! I also learned here at tsikot lang din naman! Yup, I have XTi also. I acquired it last March.

@sgotogs-Baka kailangan na nga i-reprogram yan. Before naman kasi sa ibang unit ko, nung pinalitan ko ng battery yung remote, normal lang naman. Pero try mo muna tanggalin nalang yung battery tapos after few minutes, ibalik mo yung battery. Baka gumana. Not sure lang ako kung gagana yun.

[sgotogs]

@sgotogs-Baka kailangan na nga i-reprogram yan. Before naman kasi sa ibang unit ko, nung pinalitan ko ng battery yung remote, normal lang naman. Pero try mo muna tanggalin nalang yung battery tapos after few minutes, ibalik mo yung battery. Baka gumana. Not sure lang ako kung gagana yun.

Thanks ulit Sleepcare. Ayaw pa rin. Huhuhu... sked ko na lang sa casa this weekend.

[tata_ismael]

paps, experienced the same problem with my 05 XUVi A/T. Its the KICK DOWN CABLE and DIY is impossible. An experienced mechanic needs to open the side of the A/T trans and connect the other end of the cable internally. As much as possible use OEM Kick Down Cable... hth

Oo nga sir, hindi pala simpleng baklas-kabit.. Pero tiningnan ko mabuti yung gawa ng mga mekaniko para atleast pwede ko na DIY next time.. Not that I'm hoping maputulan ako ulit.. hehe

Thank you sir!

[Sleepcare]

@sgotogs-Sige. Balitaan mo nalang kami kung ano mangyayari o ginawa.

[MR_SANT33]

@all

meron naba nakapagtry ng diy sa interior detailing dito? Gusto ko sanang diy ung interior ng xuvi ko dis sat. Ano ba pwede kung gamitin panglinis gusto ko lang sana yung nkikita lang sa bahay like laundry powder, zonrox and water

[sgotogs]

@sgotogs-Sige. Balitaan mo nalang kami kung ano mangyayari o ginawa.

di ko na kailangan dalhin sa casa, napagana ko na.
ganito ginawa ko:
- start the engine, press the button at the side panel for about 5 seconds
- while the engine is still running, press and hold the lock button until the chirp sound was heard
- switch off the engine

gumagana na lahat ng buttons. natsambahan ...